for Sanus - Speaker Stands (Pair) - Black

0points

0out of 0found this question helpful.

Was this question helpful?00

Answers

The RCA connectors may not pass through the stand post. It’s only 1/2 inch ID (inside diameter)

Posted by:

Dutch

Please wait while more information about Dutch is loaded.

Additional information about Dutch could not be loaded.

4 years, 11 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

They provide a hollow tube, with a hole near the top. Speaker wire can be fed through the tube and there is a relief notch in the base of the stand to pass the wire out from under.

The hole is not sized to allow passage of RCA plugs, banana plugs, etc. If the speaker connection is other than just the spring clamp on the wire end, then those ends would need to be applied after feeding the wire through the stand. An alternative, if the wire is black, is to run it on the exterior with wire ties or zip ties, and I'm sure that would not look bad.

Good luck!

Posted by:

sebringchad96

Please wait while more information about sebringchad96 is loaded.

Additional information about sebringchad96 could not be loaded.

4 years, 11 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

I would say no to that question.

Posted by:

JMONEY

Please wait while more information about JMONEY is loaded.

Additional information about JMONEY could not be loaded.

4 years, 11 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

Hi,

Thanks for the question. The cable channel can accommodate cords with a thickness similar to a RCA cable.

- Katie @SANUS

Posted by:

Please wait while more information about SanusStaff is loaded.

Additional information about SanusStaff could not be loaded.

4 years, 11 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

3 answers

Are the carpet spikes on the bottom of the base removable? I want to use these stands on wood floors.

Posted by:

Ron

3 years, 3 months ago

0points

0out of 0found this question helpful.

Was this question helpful?00

Answers

I have wood flooring, yes, they are removable!

Posted by:

Adam

Please wait while more information about Adam is loaded.

Additional information about Adam could not be loaded.

3 years, 3 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

They don't need to be installed in the first place. There are flat bottoms just in case if you want to stand these on wood floors.

Posted by:

StephenP

Please wait while more information about StephenP is loaded.

Additional information about StephenP could not be loaded.

3 years, 3 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

?Yes, you can remove the spikes from the bottom

Posted by:

Goodbuy

Please wait while more information about Goodbuy is loaded.

Additional information about Goodbuy could not be loaded.

3 years, 3 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

3 answers

Are these stands compatible to the Vizio home theater system

Posted by:

Anonymous

4 years, 5 months ago

0points

0out of 0found this question helpful.

Was this question helpful?00

Answers

They do work but they don't come the screws for the small speakers if your not mounting the soundbar on the wall then you can use the screws that come with it

Posted by:

Dwatson1

Please wait while more information about Dwatson1 is loaded.

Additional information about Dwatson1 could not be loaded.

4 years, 5 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

Yes,
I am using them with my rear speakers. Just unscrew the mounting screw on the back of the speaker and use it to attach the speaker to the bracket on the stand.

Posted by:

Anonymous

4 years, 5 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

These stands are compatible with most speakers up to 4 lbs.

- Katie @ SANUS

Posted by:

Additional information about SanusStaff could not be loaded.

4 years, 5 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

3 answers

Are these stands compatible with Definitive Technology ProMonitor 800 satellite speakers?

Posted by:

csimp71

7 years, 11 months ago

0points

0out of 0found this question helpful.

Was this question helpful?00

Answers

No, they aren't. The speakers have a shallow "socket" in which the anchor screw connects to the back of the speaker. Because of the feet on the bottom & the location of the hole on the speaker, the mounting options of this stand will not cover the "socket" portion of the back of the speaker, leaving the speaker half way connected to the mount.

Posted by:

Willis

7 years, 6 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

Good Morning!

Our speaker stands are meant to be universal. If the hole pattern doesn't line up, we provide neoprene pads to make sure the speakers stay in place. Please let us know if you need anything else.

Thanks,
Jake with SANUS

Posted by:

Additional information about SanusStaff could not be loaded.

7 years, 11 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

These stands hold most speakers that weigh up to 4 lbs.

Posted by:

CommunityAnswer

Answer provided by a third party; accuracy not guaranteed.

7 years, 11 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

3 answers

Speaker Compatibility

Are these stands compatible with the Insignia 670W 5.1 - C. Home Theatre System ( Model NS-HT1B51A ) speakers?

Posted by:

Anonymous

13 years, 5 months ago

-1point

0out of 1found this question helpful.

Was this question helpful?01

Answers

my speaker are15"H 8"W 12"L AND IS 7lbs each what stand would be right one

Posted by:

Anonymous

12 years, 6 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

Yes, they're supporting my front satellite speakers in my Insignia system now - rear satellites are being supported by the heavier-weight Sanus stands, but I don't believe the extra weight rating was needed.

Posted by:

PULSTAR

from

Please wait while more information about PULSTAR is loaded.

Additional information about PULSTAR could not be loaded.

13 years, 5 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

Yes, your speakers are compatible with the HTB3b Sanus speaker stands.

Posted by:

Additional information about SanusStaff could not be loaded.

13 years, 5 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

2 answers

Will the Bose 700 Speakers fit on these stands ?

Posted by:

Ken

9 months ago

0points

0out of 0found this question helpful.

Was this question helpful?00

Answers

Yes. Stands come with hardware for different size speakers

Posted by:

JenniferV

Please wait while more information about JenniferV is loaded.

Additional information about JenniferV could not be loaded.

8 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

Hi Ken,
Yes this stand should work with your speakers. Thanks,
Nate @ SANUS

Posted by:

Additional information about SanusStaff could not be loaded.

9 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

2 answers

Will these stands work with JBL Bar 9 satellite speakers?

Posted by:

Beag16

1 year ago

0points

0out of 0found this question helpful.

Was this question helpful?00

Answers

Yes they are universal.

Posted by:

Anonymous

1 year ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

If your speakers weigh more than four pounds no. I returned mine because my speakers weigh eight pounds.

Posted by:

JonC

Please wait while more information about JonC is loaded.

Additional information about JonC could not be loaded.

1 year ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

2 answers

Are the compatible with Yamaha home theater speakers?

Posted by:

1 year, 1 month ago

0points

0out of 0found this question helpful.

Was this question helpful?00

Answers

Yes, I have Yamaha speakers and these worked perfectly.

Posted by:

Anonymous

1 year, 1 month ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

The stands I have, are to short and wobbly! So I would have to say, No

Posted by:

Anonymous

1 year, 1 month ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

2 answers

Are these compatible with the Sony SA-RS3S?

Posted by:

Irene

Please wait while more information about Irene is loaded.

Additional information about Irene could not be loaded.

1 year, 1 month ago

0points

0out of 0found this question helpful.

Was this question helpful?00

Answers

I would say yes, they have multiple universal adapters for speaker mounting

Posted by:

JasonN

Please wait while more information about JasonN is loaded.

Additional information about JasonN could not be loaded.

11 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

Posted by:

Anonymous

1 year, 1 month ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

2 answers

Roku TV Wireless Speakers, Will the power cord fit through the stand tube/channel.

Posted by:

Rexdog

1 year, 3 months ago

0points

0out of 0found this question helpful.

Was this question helpful?00

Answers

I don't have those but based on the size of the hole in the tube, I would say no.

Posted by:

PeterS

Please wait while more information about PeterS is loaded.

Additional information about PeterS could not be loaded.

1 year, 2 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00

Hello,
Unfortunately the power cord will not be able to fit through the tube of this speaker stand. If you have any other questions don't hesitate to give us a call at 1-800-359-5520 or email at info@sanus.com. We're happy to help! Thanks, Nate SANUS

Posted by:

Additional information about SanusStaff could not be loaded.

1 year, 3 months ago

0points

0out of 0found this answer helpful.

Was this answer helpful?00