You need to lower and level the stationary "feet". It's rolling / moving because It's still resting on the rollers. See the manual to remove the bottom plastic panel ( about 20-3 inches high running the entire width - remove 2-3 scows and pull it off it's plastic latches). Look under the front edges and see the rollers and the screw down feet side-by side. The fridge needs to sit on the feet, not the rollers. Best / easy way (and easier than it sounds) - screw the front feet down to meet the floor, then leverage the front edge up slightly (Flat board under frame works fine...but lever again the frame, not the bottom drawer). Once lifted slightly, screw the feet down more ( 1-2 turns) so the roller is off the floor. Repeat this until you get the unit level AND the doors close on their own @ 90 degrees open. See it on Youtube too.