This Insignia™ NS-BK1TSS6 kegerator/beverage cooler holds either a 1/2 keg or a 1/4 slim keg and features an adjustable thermostat, so you can easily keep your favorite drinks cold. Two wire shelves help you maintain organization.
This reviewer is a member of the Best Buy Tech Insider Network Program. This invitation-only program provides BestBuy.com reviewers with manufacturer-supplied products for the purpose of writing honest, unbiased and usage-based reviews. Outside of receiving products to test and review, Best Buy Tech Insider Network Reviewers are not compensated in any other way.
This is my first kegerator so I can't attest to how well this performs to higher end models. However, I must say that finding a name brand stainless steel kegerator for less than $500 is difficult. I bought this on sale at Bestbuy. It works great! Assembly was easy. The unit did come dented on the door, but it was so minor it didn't feel worth taking back. It cools the beer to 34 degrees at the 5.5/6.0 setting. Keeping beer cold is key and keeping CO2 levels in check is key in reducing foam. Unfortunately, I had about 3 lbs of CO2 leak out. It was my fault for not putting the supplied O ring on the keg coupler and I don't believe I fully twisted the keg coupler properly on my second keg. However, CO2 is cheap ($15 at local paintball supply in the Atlanta area). It's only a pain in that I live 30 min from my supplier. So make sure your connections are tight and secure. The best way to check for leaks is with soapy water and by weighing the tank (it weighs 8.14 lbs, so just add 5 to that for a full tank weight excluding the regulator and hosing). A 5lb tank should last about 6 half kegs or 17 1/6 kegs (I get the 1/6 kegs to change it up more often and to save my back hauling it upstairs). So, I think the 5 lb tanks works out great. If your beer is too foamy just increase the temperature dial number on the back of the fridge (lower temp) and lower your CO2 (using less is better, right?). You may also want to consider using keg lube on your O rings and invest in a cleaning system (I use it after every 2 kegs). I recommend Brew Clean by Keg Connection and Petro Gel food grade lubricant. I don't see the need for a tower fan for this unit. Hope you enjoy it as much as I do!