Hello! The griddle for model WFG505M0MS is part number W10554125. Thank you for your inquiry about our Whirlpool® appliances.

Hello! Model WRS321SDHZ has a width of 35.5". For Standard Side-by-Side Installation: To ensure proper ventilation for your refrigerator, allow for 1/2" (1.27 cm) of space on each side and at the top. Allow for 2" (5.08 cm) of space behind the refrigerator. If your refrigerator has an ice maker, allow extra space at the back for the water line connections. When installing your refrigerator next to a fixed wall, leave a 2" (5.08 cm) minimum space on each side (depending on your model) to allow the doors to swing open. NOTES: � This refrigerator is intended for use in a location where the temperature ranges from a minimum of 55°F (13°C) to a maximum of 110°F (43°C). The preferred room temperature range for optimum performance, which reduces electricity usage and provides superior cooling, is between 60°F (15°C) and 90°F (32°C). It is recommended that you do not install the refrigerator near a heat source, such as an oven or radiator. � Normal minimum cabinet cut-out width required for product installation is 36" (91.44 cm). However, if the product is placed against an extended wall and the ability to remove the crisper pans is desired, an additional 18" (45.72 cm) of cabinet width is required, so a total cabinet opening width of 54" (137.16 cm) is recommended.

Hello! General Instructions for Door Reversal:

You will need a flathead screwdriver and usually both 5/16th and 1/4" Hexhead to remove the screws on this product.

To reverse the dryer door the hinges will need to be removed from the chassis of the product and the door with the 4 screws that hold them. Once removed the hinges can be mounted immediately to the otherside of the chassis.

The strike on the chassis of the product will need to be removed with the screw and moved over to the other side.

The catch on the door is a clip retainer, with a flathead (or pliers) you can squeeze the catch together and remove it. This too will move moved to the other side of the door.

The final steps will require the door to remain dismounted from the product. Several screws lie around the top, bottom and sides of the door that can be removed to separate the door paneling into two. The outer panel (facing outward from the product if it were mounted) must be flipped 180° and resecured so that the door handle is on the other side.

Finally the door can be remounted to the hinges and checked for alignment.

Hello! Yes, this can be laid on its back while transporting. Thank you for your inquiry about our Whirlpool® appliances.